|
Federal Testmaster case with instruction The thrift store received a group of meters by donation, so there is no information regarding the history of these items. This case looks like new. The case dimensions are 4 ¼ inches wide by 3 ¾ inches deep (4 inches overall with front fastener) by 1 ¾ inches tall. The inside has three indentations; one on the top about 1 ½ by 1 ½ inches round and two on the bottom. The meter dent is about 4 1/8 inches long and the holding post/clamp slot is about 3 ¼ inches long. The instructions fold into a small slot on its own in the top of the case next to the hinge (okay, so there are REALLY four slots in the case). The single sheet paper is titled “INSTRUCTIONS FOR FEDERAL TESTMASTERSâ€. Some highlights are: “The centerline of the contact point should be kept parallel to the working surface whenever possibleâ€, contact point diagrams, angle/correction factor table, “Are you using the right point?†For Testmaster models LT-1/2, 1, 2, 5, 6, 9-13, T-1-9, 11. There are NO working parts, so there is NO money back guarantee. (this posting is the responsibility of the poster) |
d-bird@dfwind.com (Deborah Bird) for more information. All emails will be forwarded to the poster's actual email address.
