|
You will receive Two(2) PIC18F4520-I/P NEW 40-pin High Performance, Enhanced FLASH Microchip Microcontrollers with 10-Bit A/D. * C compiler optimized architecture/instruction set * Source code compatible with the PIC16 and * Linear program memory addressing to 32 Kbytes Linear data memory addressing to 1.5 Kbytes * DC - 40 MHz osc./clock input * 4 MHz - 10 MHz osc./clock input with PLL active * 16-bit wide instructions, 8-bit wide data path * Priority levels for interrupts * 8 x 8 Single Cycle Hardware Multiplier * High current sink/source 25 mA/25 mA * Three external interrupt pins * Timer0 module: 8-bit/16-bit timer/counter with 8-bit programmable prescaler * Timer1 module: 16-bit timer/counter * Timer2 module: 8-bit timer/counter with 8-bit period register (time-base for PWM) * Timer3 module: 16-bit timer/counter * Secondary oscillator clock option - Timer1/Timer3 * Two Capture/Compare/PWM (CCP) modules. * CCP pins that can be configured as: * - Capture input: capture is 16-bit, max. resolution 6.25 ns (T * - Compare is 16-bit, max. resolution 100 ns (T * - PWM output: PWM resolution is 1- to 10-bit, max. PWM freq. @: 8-bit resolution = 156 kHz, 10-bit resolution = 39 kHz * Master Synchronous Serial Port (MSSP) module, * - 3-wire SPIâ„¢ (supports all 4 SPI modes) * - Supports RS-485 and RS-232 * Parallel Slave Port (PSP) module * Compatible 10-bit Analog-to-Digital Converter module (A/D) with: * - Conversion available during SLEEP * Programmable Low Voltage Detection (PLVD) * - Supports interrupt on-Low Voltage Detection * Programmable Brown-out Reset (BOR) * Special Microcontroller Features: * 100,000 erase/write cycle Enhanced FLASH program memory typical * 1,000,000 erase/write cycle Data EEPROM memory * FLASH/Data EEPROM Retention: > 40 years * Self-reprogrammable under software control * Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST) * Watchdog Timer (WDT) with its own On-Chip RC Oscillator for reliable operation * Programmable code protection * Selectable oscillator options including: * - 4X Phase Lock Loop (of primary oscillator) * - Secondary Oscillator (32 kHz) clock input * Single supply 5V In-Circuit Serial Programmingâ„¢ (ICSPâ„¢) via two pins * In-Circuit Debug (ICD) via two pins * Low power, high speed FLASH/EEPROM technology * Wide operating voltage range (2.0V to 5.5V) * Industrial and Extended temperature ranges * - < 1.6 mA typical @ 5V, 4 MHz Further Specification can be found at Microchip http://ww1.microchip.com/downloads/en/DeviceDoc/39564c.pdf ________________________________________________________ APACO Electronics for other great bargains! (this posting is the responsibility of the poster) |
Randi.vang@dfwind.com (Randi Vang) for more information. All emails will be forwarded to the poster's actual email address.
