|
4MS Series strobes are specially designed for use with compatible life safety communication and control equipment to alert the hear¬ing impaired of a life safety event. Strobes are available with 15 cd, 15/75 cd, 30 cd, 60 cd, and 110 cd effective flash intensity. They are fully compatible with Genesis signals. 4MS Series strobes exceed UL synchronization requirements (within 10 milliseconds other over a two-hour period) when used with a separately-installed MG1M Signal Master or SIGA-CC1S Synchroni¬zation Module. The flash from 4MS Series strobes can be noticed from almost any position in the room, corridor, or large open space. Light disper¬sion is controlled with a specially shaped reflector that directs a minimum of 12 per cent of rated light output above and below the strobe, and a minimum of 25 per cent of rated light straight out both sides. 4MS Series strobes are UL 1971 listed with both wall and ceiling cd intensity ratings (see Specifications). This is useful in areas where the Authority Having Jurisdiction (AHJ) permits ceiling-mount strobes. 4MS Series strobes are designed for 20 to 31 Vdc operation and must be connected to signal circuits that output a constant (not pulsed) voltage. A diode is used to allow full signal circuit supervi¬sion and polarized connections are made to terminals that accept up to #12 AWG (2.5mm²) wire. The strobe front plate is of steel construction finished with durable baked epoxy polyester powder-coat paint. (this posting is the responsibility of the poster) |
P_Sanchez@dfwind.com (Perry Sanchez) for more information. All emails will be forwarded to the poster's actual email address.
