|
This mold release is specifically optimized for releasing epoxy resins from most any kind of mold (I have similar release agents for polyurethane and polyester resins). Porous molds should be sealed to prevent this release from soaking into the substrate. Parts released with this product can usually be painted without any additional operations or cleaning. Do your own test, as we have not tested every possible paint. This product will withstand temperatures to 575 degrees F. Use this parting agent with epoxy laminating or casting resin. You can prolong the life of a silicone rubber mold by using this release agent. This is a new generation of aerosols that are environmentally friendly, and have much less propellant. This means that you get a lot more product for your money. Previous generations of aerosol mold release might allow you to get an ounce or two of product per can, even if the can held 16 ounces. This new generation will give you a full 12 net ounces. (this posting is the responsibility of the poster) |
kelseyhayden@dfwind.com (Kelsey Hayden) for more information. All emails will be forwarded to the poster's actual email address.
