|
Ultra-Quick Connect; Torch offers the fastest plasma torch connection Auto-Lineâ„¢ automatically connects unit to any primary input voltage from 208 to 575 volts single- or three-phase, 50 or 60 Hz. Also compensates for voltage spikes and drops within the entire range Patented Ultra-Quick Connectâ„¢ Torch offers the fastest plasma torch connection and removal in the industry. Auto-Refireâ„¢ Technology provides ultimate convenience by automatically controlling the pilot arc when cutting expanded metal or multiple pieces of metal. LVCâ„¢ line voltage compensation provides peak performance power under variable input voltage conditions (176-630 V) for steady cuts and cleaner ending cuts. Wind Tunnel Technologyâ„¢ prevents abrasive dust and particles from damaging internal components. Fan on Demandâ„¢ cooling system only operates when needed, reducing the amount of airborne dust/dirt pulled through the unit. CNC/Robotic Machine Interface is standard on all units, allowing automated control and rapid changeover to mechanized operation. Starts without high-frequency so it will not interfere with or damage controls or computers. The plasma arc is created by pulling an electrical arc between an electrode and tip. This process eliminates high frequency by forcing an electrical arc between the two pieces. Protection to extend the life of consumables and the welding torch is enhanced by our post flow circuit that provides shielding gas after you release the trigger. * Air Plasma Cutting and Gouging (PAC) * 3-Phase 80 A at 150 VDC, 60% Duty Cycle (230-575 V), 50% Duty Cycle (208 V) * 1-Phase 80 A at 150 VDC, 50% Duty Cycle (230 V), 40% Duty Cycle (208 V) * 7.8 CFM (220 L/min) at 70 PSI (483 kPa) * ICE-80T Hand-held torch with 25 ft (7.6m) cable. * Extra consumables supplied. Which include 1 standard electrode, 1 standard tip, 1 gouge tip, 1 gouge shield, 1 extended tip, and 1 deflector. * Heavy-duty work clamp with 25 ft (7.6m) cable. CLICK LINK BELOW TO SEE COMPLETE MACHINE SPECIFICATIONS http:// /pdf/spec_sheets/PC8-0.pdf (this posting is the responsibility of the poster) |
c-brooks@dfwind.com (Charlie Brooks) for more information. All emails will be forwarded to the poster's actual email address.
